ServicesLighting Installation
Lighting Installation in Dalworthington Gardens
We install new fixtures, recessed lights, ceiling fans, dimmers and outdoor lighting in your home. Before we start, you get a clear arrival window and an honest idea of how long the job will take. If something changes, we tell you right away.
New Light Where You Need It
Lighting work covers a lot of ground. It can be one dated fixture swapped for a new one. It can be a dark kitchen getting six recessed cans on a dimmer. It can be a patio that needs light so you can see the steps at night.
Most of these jobs are done in a day or less. Some need new wiring pulled through the attic or walls, and that takes longer. We tell you which kind of job yours is before we put it on the calendar, so you can plan your day around it.
If we open a box and find a problem, like scorched wires or a box that can't hold a fan, we stop and show you. You decide what happens next. Bigger wiring problems get handled as electrical repair, and you hear about it before any extra work starts.
What Our Lighting Work Covers
Fixture swaps
We take down the old fixture, check the box and the wires behind it, and mount the new one. Pendants, chandeliers, vanity bars and flush mounts all count.
Recessed lighting
We lay out the cans so the light falls evenly, cut clean holes and run new wiring to a switch. LED wafer lights work well where attic space is tight.
Ceiling fans
A fan needs a box rated to carry its weight and its wobble. We swap in a fan-rated box when the old one isn't, then balance the blades.
Dimmers and switches
We match dimmers to LED bulbs so you don't get flicker or buzz. Smart switches and three-way setups are fine too.
Outdoor and security lights
Porch lights, flood lights, motion sensors and landscape lighting, with weather-rated boxes and covers. Outside work gets sealed so water stays out.
Under-cabinet lights
Low-profile LED strips or pucks for kitchen counters, wired to a switch so you aren't plugging anything in.
Signs It's Time to Update Your Lighting
- Rooms that stay dim
- One center fixture in a kitchen or living room leaves corners dark. Adding recessed lights or a second circuit fixes that.
- Flicker or buzzing
- LED bulbs on an old dimmer often flicker or hum. Sometimes it's just the wrong dimmer. Sometimes it's a loose connection, and that one needs a look.
- Warm switch plates
- A switch or dimmer that feels warm to the touch is working too hard or has a bad connection. Don't ignore it.
- Brittle wires in old fixtures
- Older fixtures run hot, and over the years the wire insulation in the box gets stiff and cracks. Replacing the fixture is a good time to deal with it.
- A wobbly ceiling fan
- Constant wobble can mean the fan is hanging from a light-only box. That's worth fixing before it loosens further.
- Dark walkways and doors
- If you're using your phone to find the keyhole or the back steps, outdoor lighting is a simple fix.
How a Lighting Job Runs
- 1
Start with a phone call
Give us a rundown of the rooms and the kind of lights you have in mind. We'll ask about ceiling height, attic access and the fixtures you've picked. Then we book a service visit with an arrival window you can count on.
- 2
We confirm the plan on site
When we arrive, we walk the rooms with you and mark where each light goes. You get a clear picture of the work and how long it should take before we start.
- 3
We do the install
We cover floors and furniture under the work area. Attic runs in the Texas summer get scheduled for the cooler morning hours, which keeps the job moving and on time. If something takes longer than planned, we tell you as soon as we know.
- 4
We test and clean up
Once the last fixture is up, we flip each switch and run every dimmer through its full range while you watch. Any access openings get patched smooth. The old fixtures and boxes leave with us, and we vacuum the drywall dust before we go.
What Moves the Price of Lighting Work
No two lighting jobs cost the same. The biggest question is whether we're using wiring that's already there or running new. We explain the cost on the phone call and again on site before we start, so there are no surprises.
- Reusing a box or starting fresh
- Hanging a new fixture where an old one already hangs goes fast. Putting light in a spot that never had any means fishing cable and cutting in a switch, and that adds hours.
- Number of fixtures
- Six recessed lights on one circuit cost more than one, but each added light usually costs less than the first.
- Attic and ceiling access
- An open attic above a single-story room makes the job easier. Vaulted ceilings, tight attics or a second floor above add time.
- Fixture type and height
- Heavy chandeliers, tall foyers and fans that need a new box take extra hands, extra parts or a taller ladder.
- Circuit capacity
- If the circuit or panel is already full, a new line may be needed. When the panel itself is the limit, we'll talk about panel upgrades as a separate job.
Lighting Installation Questions
- Can I buy my own fixtures?
- Yes. Plenty of people pick their own lights. Just tell us the make and model on the phone so we know what we're installing. We'll check that it fits the box and the ceiling before we hang it.
- How long does recessed lighting take?
- A single room with an open attic above is usually done in one visit. More rooms, a tight attic or a second floor overhead can push it longer. We give you a realistic timeline up front, not a best-case guess.
- Do recessed lights mean holes in my ceiling?
- Each can sits in its own round opening, so those cuts come with the job. Most of the time that's all we open up. If the attic won't let us fish cable through, a small extra opening may be needed to reach the wire. We point out those spots before any cutting and patch them when the wiring is done.
- My new LED bulbs flicker when I dim them. What's wrong?
- Usually it's the dimmer. A lot of switches put in years ago were made for incandescent bulbs, and LEDs draw too little power for them to dim smoothly. Putting in an LED-rated dimmer clears it up in most homes. If the flicker hangs on after that, we look for a loose connection in the box or the fixture.
- What happens if the job runs long?
- We tell you as soon as we know, not at the end of the day. You'll know why it's taking longer and what the new finish time looks like. If it needs a second visit, we set that date with you before we leave.
- Can you add lighting during a remodel?
- Yes. If walls and ceilings are open, that's the easiest time to add lights. For bigger projects, our remodel and addition wiring work covers the full layout.
Ready for Better Light at Home
Tell us what rooms you want lit and we'll set a time that works. You'll know when we're coming and how long we'll be there.